A high-performance, conventional lead and pull spindle lathe from the manufacturer MEXPOL Machine Tools (Model TUB 40, built in 2008) is offered.   Technical data: Bed guides & Sledge: The prism guides of the machine bed as well as the guideways of the bed sledge and upper sledge show a uniform lubricating film. They are optically clean and have no deep grooves, eruptions or gross damage. Spindle box & Gear: The spindle box with the three jaw lining is neatly mounted. All mechanical levers for speed and feed selection as well as the warning signs are complete, perfectly readable and not damaged. & controls Electrical: The additional mobile control box on the right side (with emergency stop button) is undamaged. The wiring is properly guided. The type plate is perfectly legible and scratch-free. A joint work light is mounted on the spindle box. Housing & Unterbau: The stable machine bed in striking blue and light grey shows only minimal, superficial paint scrapers. The machine stands on heavy, levelling machine feet.   Collection and transport: The acquirer undertakes to collect the machine at his own expense within 21 days of the surcharge. The loading as well as the proper load securing are carried out exclusively by the buyer or the pick-up agent commissioned by him. Disassembly and removal from the premises shall be carried out by the acquirer in his or her own responsibility. The machine is located on the ground floor and can therefore be transported flat. Due to the weight of almost 1.7 tons, the removal by the acquirer with corresponding lifting equipment is to be planned.