Wood chippers Three-point cultivation   Manufacturer: Tünnissen (now: TS Industrie) Type: 431 CS Serial No: 02/373/3 Read-out hours: 02856 Three-point cultivation, CAT II Commissioning: 11.12.2007 Last UVV test: 3/2025 Color: orange Drive: via PTO shaft with slide clutch and freewheel   Data not available. Manufacturer: Power requirement approx.: 80 hp Max. wood diameter: 23 cm Diameter of chopper: 900 mm Width of feed: 310 mm Dimensions funnel in mm: W x H 1,260 x 930 Dimensions approx. in mm: L x W x H 2,000 x 1,500 x 2,800 Weight approx.: 1,200 kg   Equipment: swivelling chipper part 180 degrees, cutting length adjustment (see stepless hydraulic speed adjustment feed rollers), automatic overload protection via HMC 542 control module (automatic shut-off feed at speed drop), central lubricating console, lighting, additional touch roller rear mounted   Operating instructions and spare parts list available, with 2 spare knives as well as the following new parts: 2 countercuts, 2 pull springs from the feed, V-belt set, various safety switches and solenoid valve   Condition: Due to service life paint fades and corrosion approaches, various safety stickers poorly legible, due to age/use traces of use available, PTO shaft protection damaged, a fixing screw to hood defective, various welding and reinforcement work on the bogie carried out, due damage had to be replaced, hacker was regularly maintained until last 3/2021, since the time only rarely used, why the hacker should now be checked and maintained, currently trial run carried out as far as ready for use. Device was always under the roof.   Renewed: 2013 at the entry angle gearbox top 2014 Hack disk (s. damage) 2015 ejection tower 2019 various hydraulic solenoid valves   The bidder is strongly advised to inspect the equipment before making a bid. Dates please with Mr. Peter Schneider under Tel. 07251/79-693.   No expert opinion and no evaluation was carried out. The value is based on a value at the time of payment.   After a surcharge has been paid, the equipment must be collected from the purchaser within 10 days. The pickup itself is responsible for loading and proper transport.   All data have been compiled to the best of our knowledge. Errors and transmission errors are reserved. The actual device condition is decisive.