For the auction, a full harvester/harvesting machine of the brand Gäumtigm, Model MultiCombine HC 3400 will be delivered by way of forced execution.Manufacturer: GäummModel No.: MultiCombine HC3400Vehicle type: Agricultural / Harvesting machineBuilding: full harvestersFirst registration: 24.08.2015Power: 180 kWHeavy room: 6.057 cm3Power: Diesel Transmission: AutomaticOperating hours: 1.796 read Operating hoursPermissible total weight: 18,000 kgDimensions: approx. 11.088 mm x 3,000 mm x 4,000 mmColor: greyAccording to the expert's report, the equipment includes a hydraulic drive 150 l / maximum 200 bar, a maximum cutting height of 3.40 m, a working speed of approx. 10–12 km/h, a bunker capacity of approx.20 m3, a ground clearance of approx.1.20 to 1.60 m, an GPS/Live camera system as well as a comfort cabin.The registration certificate Part I is available in the original. A HU test report was also available to the expert in the original.The machine was inspected and evaluated on 21.09.2026 by an expert of TÜV Rheinland Schaden- und Wertbericht GmbH.The general condition was described in the report as age and running performance equivalent. The driving readiness is indicated in the test report as "ready to operate". A test was not carried out. Similarly, a test run of the propulsion machine was not possible under the given circumstances. The following defects were found, among other things, according to the report:Battery defectiveService booklet missingOperating manual missingReplacement key missingNo proof of inspection / serviceGuided sheet deformedOn-board wall deformedTransport belt wornAscent ladder deformedRight exterior mirror brokenHeck frame DeformedRight rear light brokenRight side marking light brokenBlinking light on the front rightBreaked regarding the further technical condition, the equipment, the tyres as well as all detected damages and defects is expressly referred to the present expert report. Condition.Warranty claims due to a defect in the law or due to material defect are excluded in accordance with § 806 ZPO.An inspection of the machine before placing a bid is recommended.