For the acquisition is a used vacuum freeze drying system of the company F. Christ, built in 2010. The plant was last put into operation in 2024 and was maintained in October 2024. The system consists of several coordinated components for the execution of freeze drying processes.   Plant and components:   1x Christ Alpha 1-4 LD plus – small capacitor 1x EDWARDS RV8 – vacuum pump Model: RV8 Code No: A65401903 Serial No.: 220607636 Weight: 29 kg 1x Christ Lyo Cabinet 2-10 – Freezer with heated floors 1x Christ Delta 1-24 LSC – large capacitor 1x Pfeiffer Vacuum Duo Line DUO 35 – rotary pusher vacuum pump Model: DUO 35 P/N: PK D45 602 E S/N: 22135877 Oil filling: 3,2 l Weight: 68 kg Process documentation software LyoLog-32   Equipment and technical specifications: The Christ Lyo Cabinet 2-10 has a total of 9 heatable floors, of which 6 are removable. The system has a small and a large capacitor. The vacuum pumps require an oil change during operation, according to the available information, approximately every 300 operating hours. The technical data of the individual system components can be sent on request.   Operating and maintenance information: Year of construction: 2010 Last commissioning: 2024 Last maintenance: October 2024   The condition of the plant corresponds to the condition existing at the time of inspection or transfer. Further information on technical functionality is not guaranteed.   Documents (on request):   Maintenance protocol of the company F. Christian of October 2024 Technical data Christ Alpha 1-4 LD plus Technical data Christ Delta 1-24 LSC Technical data Christ Lyo Cabinet 2-10   The above documents can be made available by e-mail on request before submitting a bid.   Further existing documents, in particular operating instructions and schematics, are also available and can be handed over to the acquirer when the plant is handed over.   Previous use and other applications:   The freeze drying system was used at the Federal Archives for the gentle drying and preservation of moist or water-damaged archive material.   In principle, however, the installation is not limited to this scope. Due to its technical design, it is also suitable for numerous further freeze drying processes in the laboratory, research and technical centre area. Possible applications include freeze drying of biological samples, food, plant materials, sensitive chemical products and other applications in research and development. The specific suitability for a specific application is dependent on the properties of the material to be dried as well as the technical and safety-relevant requirements of the respective process.   Extraction, transport and construction:   The removal, loading, transport, construction and installation at the new site must be initiated by the acquirer and carried out at his own expense.   There is a truck service option at the current location. An elevator with a load capacity of up to 4,000 kg is available for the transport of the system components for truck service.   The Lyo Cabinet was built at the current location by means of a pulley. A corresponding device is still anchored in the ceiling.   Before mining, the acquirer must independently check whether the intended transport routes, access points, lift dimensions and other local conditions are suitable for the transport and lifting equipment he uses.   Estimated costs for dismantling and construction:   According to written information from the company Christ, approx. 2 hours are required for the dismantling of the plant and 4 to 6 hours for the construction with a test run at the new site. Repair times are not included and may be calculated according to effort.   The estimated total costs for dismantling, construction and testing were estimated by the company Christ about 3,000,00 EUR net, depending on the respective travel charges. Transport costs are not included. The above information on working hours and costs shall be without prejudice to: